Hot
Sale

Tuck Yourself Tucking Tape Kit

Glassco- 521.303.08- Crucible, Quartz- 100 ML (Pack of 02)
Glassco- 521.303.08- Crucible, Quartz- 100 ML (Pack of 02)

$ 9.27

Add to Wishlist
Product name: Crystallizing Dishes without Spout, 190x100MM Supplied by: Biohall Crystallizing Dishes are manufactured as per ASTM E 438 TYPE 1 CLASS BORO 3.3 GLASS, comply to DIN and USP Standards. 190x100MM. Catalogue number: BLS.2009 Biohall makes all its Products from tubing of ASTM E-438 TYPE I, CLASS A BORO 3.3 GLASS. The automated and semi automated machines are used to produce the products as per the technical drawings made according to international standards. Dimensional checks are performed by the QC departments for their adherence to the defined standards. Each piece produced is checked for the stresses which might cause the cracking of the glasses and also for scrathes which might happen while handling at each step for producing glass quality. Every single piece produced is essentially checked for the wall thickness to determine the strength and ensure adherence to standards set as per DIN/ASTM/ISO. The Joints are tested for their fitness as per their taper of cones and sockets to ensure highest level fitness and ensure no leaks. Vaccum tests are performed subsequent to the fitness checks to ensure absolutely no leaks. The Glassware is checked for the print quality at two stages first before putting in the furnance and after taking out of furnance, this ensure no product with defective print reaches the market.

How To Tuck For Drag

Step 1) Preparation: For obvious reasons, do not apply tucking tape over pubic hair! The region should be shaved or waxed, although short stubble is fine too. For best results, the skin must also be clean and dry.

Step 2) Tubular Gauze: Cover the head and shaft of the penis with a piece of tubular gauze. Twist the free end so as to close the tubular gauze at the tip of the penis, then roll the remaining tubular gauze back down over the shaft. Massage the tubular gauze lengthwise for a snugger fit.

Step 3) Start The Tape: Remove the first inch of tape backing paper and apply the tucking tape to the pubic region. Start 1″ to 2″ above the base of your shaft, and press the tape firmly to establish strong adhesion.

Step 4) Time To Tuck! Use your fingertips to guide the testicles upward into the abdominal cavity (explained below). Then pull the shaft and loose skin rearward, toward the buttocks. Reach around from behind, and hold everything in place with one hand.

Step 5) Apply More Tape: Use your free hand to remove a bit more backing paper, and apply more tape. Work from front to rear, keeping the tape taught for a tight tuck.

Step 6) Finish Taping: Pull the tail towards the small of your back.

Tape Removal

For a gentle release, some customers prefer to remove tucking tape in the bath or shower. Others wipe the tape with our Glassco-229.202.05-Beaker, Low form with spout-100 ML (Pack of 10) and give it a minute to soak in.

How Do Drag Queens Tuck?

There are numerous ways to tuck for drag with Tuck Yourself Tucking Kits. Most of them involve pushing the testicles upwards, and into the abdominal cavity. Biological males are born with undescended testicles, and by 9 months old, the testicles descend via the inguinal canal. Even as adults, the testicles can usually be manipulated back into the the abdominal cavity with minimal discomfort. From there, everything else is pulled tightly back, towards the buttocks. Typically, the tuck is secured with tape, or a supportive garment called a Glassco-229.202.10-Beaker, Low form with spout-1000 ML (Pack of 10). Tucking tape provides an extremely flat tuck and maximum security. For this reason, tucking tape is very popular among drag performers. It is also a natural choice for swim suits, leggings, tight skirts, and other form-fitting attire. In contrast, many crossdressers prefer the convenience and comfort of a gaff, especially when wearing paired with less revealing outfits.

Watch Diana’s YouTube tutorial for even more drag queen tuck tips.