Why this one and not the other AVS car cable? We have two cigarette lighter cables for Starlink Mini in the AVS range. This is the higher-powered one. Where the other cable runs at 60W with a built-in digital voltage display, this one steps up to 105W max via an external aluminium step-up converter unit. If you’re running your Starlink Mini hard, in a truck, a campervan, or anywhere signal demand is high, this is the one to go for. Built for 12V and 24V vehicle systems Designed by AVS and built to our specs, it plugs into any cigarette lighter socket and steps the voltage up to the 30V DC your Starlink Mini needs to run. The input lead is 16 AWG with a 15A inline fuse, and the cigarette lighter adapter is rated to 15A continuous using tin-plated copper contacts and a spring contact design that keeps firm socket pressure without running hot. The output runs through a 30cm 16 AWG pigtail from the converter into 3m or 5m of 18 AWG cable with a male DC connector straight to your dish. Compatible with Starlink Mini Available in 3m for most setups, or 5m if you need the extra reach. Note:  This product is engineered, designed and manufactured by Air Vision Systems.  This product is not affiliated with or endorsed by Starlink or SpaceX. Air Vision Systems is proudly 100% Kiwi owned, and New Zealand based. All products are stocked and shipped from within New Zealand for fast delivery and local support.

How To Tuck For Drag

Step 1) Preparation: For obvious reasons, do not apply tucking tape over pubic hair! The region should be shaved or waxed, although short stubble is fine too. For best results, the skin must also be clean and dry.

Step 2) Tubular Gauze: Cover the head and shaft of the penis with a piece of tubular gauze. Twist the free end so as to close the tubular gauze at the tip of the penis, then roll the remaining tubular gauze back down over the shaft. Massage the tubular gauze lengthwise for a snugger fit.

Step 3) Start The Tape: Remove the first inch of tape backing paper and apply the tucking tape to the pubic region. Start 1″ to 2″ above the base of your shaft, and press the tape firmly to establish strong adhesion.

Step 4) Time To Tuck! Use your fingertips to guide the testicles upward into the abdominal cavity (explained below). Then pull the shaft and loose skin rearward, toward the buttocks. Reach around from behind, and hold everything in place with one hand.

Step 5) Apply More Tape: Use your free hand to remove a bit more backing paper, and apply more tape. Work from front to rear, keeping the tape taught for a tight tuck.

Step 6) Finish Taping: Pull the tail towards the small of your back.

Tape Removal

For a gentle release, some customers prefer to remove tucking tape in the bath or shower. Others wipe the tape with our Starlink Gen 3 Step-Up Converter with Alligator Clips and give it a minute to soak in.

How Do Drag Queens Tuck?

There are numerous ways to tuck for drag with Tuck Yourself Tucking Kits. Most of them involve pushing the testicles upwards, and into the abdominal cavity. Biological males are born with undescended testicles, and by 9 months old, the testicles descend via the inguinal canal. Even as adults, the testicles can usually be manipulated back into the the abdominal cavity with minimal discomfort. From there, everything else is pulled tightly back, towards the buttocks. Typically, the tuck is secured with tape, or a supportive garment called a Starlink Gen 3 and Mini Power Supply – Replacement Unit. Tucking tape provides an extremely flat tuck and maximum security. For this reason, tucking tape is very popular among drag performers. It is also a natural choice for swim suits, leggings, tight skirts, and other form-fitting attire. In contrast, many crossdressers prefer the convenience and comfort of a gaff, especially when wearing paired with less revealing outfits.

Watch Diana’s YouTube tutorial for even more drag queen tuck tips.